![]() Pin4 (VS): This is a voltage supply pin, connected to +5V.Pin2 & 3(Output 1 & 2): These two pins are output pins of the H- Bridge A where the current supplies throughout the load which is monitored at pin-1.Pin1 (Current Sensing A): This pin is used to control the flow of the current of the load.This IC includes dual bridges namely H-bridge A & H-bridge B. ![]() The pin configurations of L298 dual full-bridge driver IC include 15-pins where each pin is discussed below. All the enable and input pins in this IC work with 5V TTL logic to make the connection simple with different types of microcontrollers. ![]() Similarly, enable pins can also be used to make all the outputs active simultaneously. Here, current sense pins are connected to the ground terminal but we can also include a low-value resistor where its voltage reading is relative to the current. L298 Motor Driver ICĮach bridge in this IC includes two current sense pins like CSA & CSB and enable pins like ENA & ENB. ![]() Here, One H Bridge is used to switch the polarity to control the motor direction whereas pair of H bridges are used for controlling a bipolar stepper motor. L298 IC includes four separate power amplifiers where two amplifiers can form H-bridge A and the other two types of amplifiers can form H-bridge B.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |